How can I see the linked req. when I execute a testcase

[ibreestraat]

I created a requirement:
Title: Measurements on test eye
Status : Valid
Type : Use Case
Number of test cases needed : 6

I linked it to 6 testcases by 'Assign requirements'

When I add one of these testcases to my testplan and I want to execute I see the requirements link but when I click to open the project screen opens (same as when you press 'Project' at the top). Why is the requirement not shown??

[fman]

please check on Mantis for a similar issue (remember to remove STATUS FILTER).
If you do not find a similar issue, please report one.