Blocked status shown as pass in database

[jccalma]

Hello,

I'm trying to experiment with TestLink statuses in the database and I noticed that the Blocked status is shown as p in its database. Is there a way to configure this so it would be b instead of p

[fman]

If this is happening you have some strange config issue
The standard code for Blocked is b

[jccalma]

If this is happening you have some strange config issue
The standard code for Blocked is b

Would you know where I can check this? I haven't done any changes with my config

[fman]

Create a test suite with a test case, create a test plan , build and execute this case as blocked , then check your db

[jccalma]

Create a test suite with a test case, create a test plan , build and execute this case as blocked , then check your db

I already mentioned it in my initial post that it shows as passed when it's blocked... anyway, I did it again and it didn't change anything

[fman]

Your installation is broken.
Do a fresh install and retest

[jccalma]

I already did since I don't think there's a solution to my existing problem. Thanks

[fman]

Would you mind to provide feedback?