Page 1 of 1
Blocked status shown as pass in database
Posted: Tue Feb 09, 2021 6:52 am
by jccalma
Hello,
I'm trying to experiment with TestLink statuses in the database and I noticed that the Blocked status is shown as p in its database. Is there a way to configure this so it would be b instead of p
Re: Blocked status shown as pass in database
Posted: Tue Feb 09, 2021 10:19 am
by fman
If this is happening you have some strange config issue
The standard code for Blocked is b
Re: Blocked status shown as pass in database
Posted: Tue Feb 09, 2021 10:24 am
by jccalma
fman wrote: ↑Tue Feb 09, 2021 10:19 am
If this is happening you have some strange config issue
The standard code for Blocked is b
Would you know where I can check this? I haven't done any changes with my config
Re: Blocked status shown as pass in database
Posted: Tue Feb 09, 2021 9:50 pm
by fman
Create a test suite with a test case, create a test plan , build and execute this case as blocked , then check your db
Re: Blocked status shown as pass in database
Posted: Wed Feb 10, 2021 1:32 am
by jccalma
fman wrote: ↑Tue Feb 09, 2021 9:50 pm
Create a test suite with a test case, create a test plan , build and execute this case as blocked , then check your db
I already mentioned it in my initial post that it shows as passed when it's blocked... anyway, I did it again and it didn't change anything
Re: Blocked status shown as pass in database
Posted: Wed Feb 10, 2021 6:13 pm
by fman
Your installation is broken.
Do a fresh install and retest
Re: Blocked status shown as pass in database
Posted: Thu Feb 11, 2021 12:58 am
by jccalma
I already did since I don't think there's a solution to my existing problem. Thanks
Re: Blocked status shown as pass in database
Posted: Fri Feb 12, 2021 3:28 pm
by fman
Would you mind to provide feedback?