Requirement based report - Testlink 1.8.3

[jesalb]

Hi,

Greetings!

We are using Testlink tool to manage our test cases. We had following questions, so it would be great if you can guide us regarding the same -

1) When we execute the test cases, we get only 4 status (Not Run, Passed, Failed and Blocked). But we need to add one status as N/A or “Not Applicable”. Is it possible to

add a new status to the test case while execution?

2) In the Report matrix, we get the Failed, Not Run and Blocked test case reports in the following format –

Test Suite Test Case ID Version Build Run by Date Description Bugs

But we do not get the Test case “summary” field in this report. So is it possible to add the "Summary" field in the report?

3) "Requirement based report" - when we assign a requirement to a test case and assign that test case to a Test plan and execute it, it shows the status of that test case

as "Not Run". However in the " General Test Plan Metrics", it shows the result as "Pass / Fail". So please let us know why the status in "Requirement based report" shows

as "Not Run"?

Referred the Testlink site and found the following two posts regarding the same:

http://www.teamst.org/phpBB2/viewtopic. ... f5dcdecf1a

http://www.teamst.org/phpBB2/viewtopic. ... 19a73272a9

However I was just curious to know if there are any simpler solutions to these issues?

Thanks and Regards,
Jesal

[raviranjan]

Were you able to get a solution to this problem? I am having a similar issue and the links posted by you in the email does not seem to work.